BE Avionics Engineering

Control system adjust the orientation of a vehicle about its:-

What are the numbers of non selective interrogation in mode S system:-

The impedance  at  the  center  of  the  antenna  is  known as :-

Which device is needed  for  carburetor  used in aircraft application:-

What is the maximum operating speed of the A350 :-

which bits  is transmitted first in a serial communication;-

Which is  not one  of the type of  driven  array  antenna :-

What is the time gap between each pulse in an interrogation pulse pair for a DME:-

Skin friction drag is defined as drag due to friction between skin and fluid flow:-

voice signals  can not  be  directly  transmitted  by  radio;-

The  possibility  of one  phased  array  radar  to  act as  multiple   radars  is  called as :-

What type of controller is used in an auto flare control;-

A two stage amplifier has an input power of 30 μW and output power of 1.5 mW.one stage has a gain of 3. What is the gain of the second stage:-

What is the full form of TAWS:-

What is the process called when the state vector is calculated on board the vehicle:-

which is not a  type of  modulation;-

Autopilot provides FBW command of roll, pitch and yaw:-

In what type of display is the image projected directly to the retina of the pilot :-

Which  part of  the  transmitter  subsystem   modulated  the  baseband  signal ;-

Which is not  factor for calculating speed breaches by the FMS:-

In  primary radar  Friend  or foe  identification is possible :-

what is the minimum  frequency   of  sampling  so  that the  analog  waveform is  adequately  expressed ;-

LORAN stands for Long range navigation:-

The information signal is otherwise referred to as;-

Aircrafts are streamlined from nose to tail reduce:-