BE Aerospace Engineering Quiz

When knife and pitman run in a straight line, then cutter bar is in:-

How  vortex  filament  are arrange  in the vortex  sheet :-

A nursery required for  transplantation paddy seeding in one hectare of land is:-

Does  lift  and   drag  of  an airfoil  depends  on  angle  of  attack :-

Is  loading  of  lifting  surfaces  antedates  the  achievements  of  powered  flights :-

D check is also known as ;-

To improve the drag at subsonic speed supercritical airfoil is used:-

Is  surface  is   perturb  the  boundary  layer  and  promote  turbulence ;-

Say bolt universal seconds is related with me:-

Coefficient of pressure is  a :-

The  dynamic  pressure is  difference of  total and  static  pressure :-

Is  numerical  solution of  source and  vortex  panel  technique  has  revolutionized   the  analysis   of low  speed  flow ;[

Inside  a  wind tunnel  ,  the  area  further  decreases  from A2 to A3   that section is called as ;-

The viscosity is measured in;-

ARINC 708 is the type of:-

Specified yield is the property of:-

Maximum noise level from a tractor mean the operator's ear should not exceed:-

The forces acting on MB plough are;-

The density of soil organic matter is usually about :-

A device used for manual harvesting of crops :-

Is  induced  drag produce  lift ;-

Who became the youngest female Aerospace engineer of Pakistan:-

Is  lift  and  drag  are the total  aerodynamic  force acting the  body :-

The  aircraft fly  in  the  atmosphere  due to which  principle :-

Positive lift is produced by symmetric airfoil:-